Hello. I seem to not be able to launch the CME-GUI on a 2801 router. This happens to be my first attempt at such a thing but I'm followed the instructions in the Cisco Unified Communications Manager Express System Administration Guide for setting up the following items:
ip http server
ip http path flash:CME-GUI
ip http authentication local
web admin system name admin secret 5 (etc)
I'm connected to the switch via a 7961 phone and can successfully ping the "service-module" ip address. But Internet Explorer won't launch (http://192.168.2.10/ccme.html the CME GUI.
I seem to be missing something and don't quite know what that might be.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...