Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Unable to session to AIM CUE card

I have configured the IP addresses of the service engine and the service module. When I attempt to session to the CUE, I get a strange exception error message "EXCEPTION: /sw/info/ps: -5: out of memor for event sources" This messages repeats about 7 or 8 times and then I get some warning text asking me to verify the Service Engine IP address and default gateway are configured correctly .

I have attached captures of a sh run and the running error message

Jeff

1 REPLY
Silver

Re: Unable to session to AIM CUE card

It happens when the NM's IP is not configured properly on the router side CLIs. Configure the NM's IP on the router CLI and reload the NM. Refer to the bugs CSCeh18590 and CSCeg66388.

253
Views
0
Helpful
1
Replies
CreatePlease to create content