I am interested in setting up unfied messaging with CUC 8.5 and exchange 2010. I have downloaded the integration guides however they only have instructions for single inbox. I am only interested in sending voicemails to the recepient's inbox only. How can this be done and is there a guide available? I have only done this for Unity many years ago so I am not sure of the procedure for unity connection.
I have been configuring and troubleshooting this unified messaging all day. Perhaps you can take a look at the error I got and advise on some checks to make. i have followed all the steps for the guide and the unified service was tested successful however the user account test is getting the error 500 code and I am not sure what else to check here. I have attached some screenshots for you to verify.
Okay I saw that the NLTM method is actually windows authentication on IIS v7. So i changed it and now I am getting a different error, see attached. I am going to re-create the service account and see if that helps.
I got through with this issue and it seems that the exchange required sp 1 installed along with all the recommended hotfixes. after this was done the ews editor was able to access the mailbox with the unified messaging account created which was not allowed before. I have the auth set as NLTM and https.
I plan to wipe and redo to see if the same occurs, i will update once completed.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.