Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unity 4.0(3) and Callhandler

Hello Folks

I have a problem with a callhandler, I created a menu using a callhandler that if the user press 1 it will go to a subscribers greeting and if they press 2 it will go to a different subscriber greeting, however when I test it

everysingle time I press either 1 or 2

I get "sorry this system is temporarily unable to complete your call, good bye"

If I check the port status monitor

I see after the dtmf is gathered

failsafe

event is [errorEvent]

state- gto failsafe conversation

Any ideas ?

thank you

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Unity 4.0(3) and Callhandler

Make sure the call handler has an owner and a message recipient.

rlp

3 REPLIES
Silver

Re: Unity 4.0(3) and Callhandler

Make sure the call handler has an owner and a message recipient.

rlp

New Member

Re: Unity 4.0(3) and Callhandler

Thank you

I was missing the message recipient

that worked

Silver

Re: Unity 4.0(3) and Callhandler

Glad I finally helped :-)

rlp

99
Views
0
Helpful
3
Replies
CreatePlease login to create content