Unity 4.0(5) - Change from Import to Create and Import
Is there an easy way to go from an installation that was configured for just importing users and then the customer changes their mind and wants to Create/Import within side unity?
I know of the permissions within side Exchange, I reran the permissions wizard and even the install to change options but I did not see the one message again of when it wants to run the message store wizard of choosing between th etwo choices. Create and Import or just import.
Re: Unity 4.0(5) - Change from Import to Create and Import
You can change this in the registry easily enough as long as you have the permissions configured properly (sounds like you do).
open the registry with Regsvr32.exe
Go to HKLM\Software\Active Voice\SystemParameters\1.0\
you'll see a key named "DisableNewExchSub" and it'll be set to 1 for you - change it to 0 and it'll allow creation of new users instead of importing only. No restart is needed for this, just close out the SA and reopen it for the change to take effect.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.