Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

VIP Super Bronze

Unity 4.0.5 "Caller system transfer issue"

Guys,

I am having a strange problem with unity caller system transfer. I have setup a CH for auto attendant. I have configured key mappings to send call to caller system transfer. But each time I enter the extension to be xfered to, unity says "you cannot be tranferred to this extension"

When I use the same extension on "attempt transfer for operator, ring subscriber extension" the call goes through. So I do not have a CSS, partiton issue.. Is there something that needs to be done to allow caller system transfer.

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
4 REPLIES
Hall of Fame Super Red

Re: Unity 4.0.5 "Caller system transfer issue"

Hey deji,

Just back from a nice "long" weekend here :) Have you checked the numbers in question within the CS_Default_System_Transfer restriction table to see if it permits it.

From this good doc;

http://www.cisco.com/en/US/docs/voice_ip_comm/unity/404/administration/guide/ex/sag0240.html#wpxref46866

Hope this helps!

Rob

VIP Super Bronze

Re: Unity 4.0.5 "Caller system transfer issue"

Rob,

After lots of poking around, I actually figured out it was this!. Up until this morning, I thought there was just the default transfer restriction table and thats the one I was looking at, till I stimbled on this one. +5 point for your excellent and as usual helpful response

Thanks. Good to kow you are having fun :)

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
New Member

Re: Unity 4.0.5 "Caller system transfer issue"

(Oops, sorry, I missed Rob's response and gave the same answer... anyway, here are links to the 4.0(5) version of the guide.)

It sounds like you need to check the restriction table that governs caller system transfers, CS_Default_System_Transfer.

Here's a link for info on caller system transfers in 4.0(5):

[with Exchange] http://www.cisco.com/en/US/docs/voice_ip_comm/unity/405/administration/guide/ex/sag_0045.html#Setting_Up_System_Transfers

[with Domino] http://www.cisco.com/en/US/docs/voice_ip_comm/unity/405/administration/guide/dom/sag_0045.html#Setting_Up_System_Transfers

You can find a chapter on restriction tables in the same guide...

VIP Super Bronze

Re: Unity 4.0.5 "Caller system transfer issue"

Tana,

Thanks, I resolved this already. +5 points for you

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
156
Views
10
Helpful
4
Replies