Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Unity 4.05 Alternate MWI setting in the Cisco0002.ini?

I have never seen this before, so I'm hoping Jeff or someone can weigh in on it.

I've got a customer who has Unity 4.05 integrated into both a 4.1 Callmanager cluster and A Nortel Option PBX network. The very strange thing is that Unity only shows the Callmanager integration.

The Nortel forwards calls to unity via an MGCP PRI gateway integration on the Callmanager. The Unity servers have PBXLink devices attached and supposedly are only used to light the MWI on the nortel. The CISCO0002.ini file has an interesting section that is like so:

[Identity]

SwitchManufacturer=CISCO

SwitchModel=CallManager

SwitchSoftwareVersion=3.0(1) or later

IntegrationType=TAPI

[MWI Default]

MWIType=TAPI

Active=Yes

CodesChangeable=No

[Alternate MWI]

Active=Yes

Digit=Z

MWIType=Serial

SerialConfiguration=SMDI

Users on the Nortel have their Subscriber > Messages >MWI Extensions set to ZX

I'm suspecting they're broadcasting MWI to both switches here.

Here is the $64000 question: I'm about to upgrade these servers from 4.05 to 4.2.1, what is the chance that this upgrade will break this functionality?

Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Unity 4.05 Alternate MWI setting in the Cisco0002.ini?

For a basic overview of what they're probably doing here, have a look at the "MWIs for Extensions on a Non-Integrated Phone System" section in your favorite Unity-CCM integration guide. Here's one...

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_configuration_guide09186a00801e9e37.html#wp1329420

Regards,

Eric

2 REPLIES
Cisco Employee

Re: Unity 4.05 Alternate MWI setting in the Cisco0002.ini?

For a basic overview of what they're probably doing here, have a look at the "MWIs for Extensions on a Non-Integrated Phone System" section in your favorite Unity-CCM integration guide. Here's one...

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_configuration_guide09186a00801e9e37.html#wp1329420

Regards,

Eric

New Member

Re: Unity 4.05 Alternate MWI setting in the Cisco0002.ini?

This is exactly it, since it's in here I'm suspecting it's somewhat supported.

Thanks for the info!

100
Views
0
Helpful
2
Replies