Just upgraded to 4.05 over the weekend. During the update, the primary server stated it had trouble with the TSP, so it would need to updated manually after the install completed, which we did. Other than that, the upgrade went smoothly. This morning, the server went into failover as a call was answered on port 1 of the failover, and there were lots of avl porst on the primary. We disabled the failover so it wont answer on the inactive server anymore and failed it back to the primary. After a few hours, we are now getting swamped with the following wav errors in events logs:
Event Type: Error
Event Source: CiscoUnity_ConvSubscriber
Event Category: Error
Event ID: 119
Time: 1:16:14 PM
An unexpected error has occured while a subscriber is on the phone with Unity. This can potentially result in the subscriber hearing the failsafe conversation. Technical details are - IAvDohMessageIterator::SetFilter returned [0x80040115] on line 743 of file e:\Views\cs_CU22.214.171.124\un_Conv1\Scripted\ConvSub\MsgStack.cpp.
Unable to get to new messages after having played the stack once. After playing of the stack, Unity checks for any new messages that were delivered while the stack was being listened to. For detailed diagnosis, turn on all the Subscriber Conversation diagnostics and look for errors. GetNextMessage Procedure returned [0x80040115] on line 1149 of file e:\Views\cs_CU126.96.36.199\un_Conv1\Scripted\ConvSub\MsgStack.cpp.
Cisco Unity's multi-media component has enountered a serious error.
A serious failure has occurred on port 7 during wav media processing. Depending upon the severity of the failure, parties on this call could experience unexpected behavior or be disconnected. In some cases, further calls on this port will not be handled correctly.
Thread 0x00001058 had a Failure on Port 7 in AvWav
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.