Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Unity 4.1 to Unity Connection 7.1(2a), MWI Question

I'm preparing to migrate 700 users from Unity 4.1 to Unity Conn HA 7.1(2a) with a CUCM 4.1.3 integration. I have the luxury of being able to have both servers active concurrently. I am going to set up a new VM Pilot and ports, but I was wondering if I can use the same MWI on/off numbers for both the Unity 4.1 and the Unity Connection 7.1(2a).

Any ideas? Thanks.

1 REPLY
Hall of Fame Super Red

Re: Unity 4.1 to Unity Connection 7.1(2a), MWI Question

Hi Kyle,

We have a dual integration right now with UC 7.x and setup different MWI ON/OFF numbers just to keep things completely separate. I would recommend doing the same thing. We were worried about MWI nightly re-sync etc.

Hope this helps!

Rob

121
Views
0
Helpful
1
Replies