Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unity 4.2(1) and BulkEdit - Changing "Before/After..." Info

Is their a way with the Unity Bulk Editor to change the "Before playing each message, play - Sender's Info, Message Number, Time stamp" - I have not seen these options in the editor. I want to be able to uncheck the time stamp from after playing each message and check it before with many subscribers. Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Unity 4.2(1) and BulkEdit - Changing "Before/After..." Info

Hi Jeremy,

Have a look at the following, perhaps this is what you are looking for;

Bulk Edit

Conversation

Message Review

Announce timestamp. "You can select before message or after message in this drop down to dictate if the timestamps are played before subscribers hear the message or after when they are listening to messages over the phone."

From this good Help doc;

http://www.ciscounitytools.com/HelpFiles/BulkEdit4x/index.html

Hope this helps!

Rob

Please remember to rate helpful posts.....

1 REPLY
Hall of Fame Super Red

Re: Unity 4.2(1) and BulkEdit - Changing "Before/After..." Info

Hi Jeremy,

Have a look at the following, perhaps this is what you are looking for;

Bulk Edit

Conversation

Message Review

Announce timestamp. "You can select before message or after message in this drop down to dictate if the timestamps are played before subscribers hear the message or after when they are listening to messages over the phone."

From this good Help doc;

http://www.ciscounitytools.com/HelpFiles/BulkEdit4x/index.html

Hope this helps!

Rob

Please remember to rate helpful posts.....

97
Views
0
Helpful
1
Replies
CreatePlease login to create content