Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unity 4.2 installation problem

Hi everyone,

when I run Unity 4.2 installation CD1 setup.exe program, I got an error msg like this

While trying to install the Sentinel System Driver, Windows Installer returned a failure code: 2

after this, Unity 4.2 installation exit.

any ideas?

thanks

2 REPLIES
Bronze

Re: Unity 4.2 installation problem

By any chance are you installing through Windows Terminal services? The Sentinel system driver cannot be installed by using Terminal Services. If this is a remote system, you'll need to use VNC. Before you re-run the Cisco Unity Setup program, install the driver by doing the following procedure on the Cisco Unity server:

1. On the Cisco Unity server, insert Cisco Unity Disc 1 in the CD-ROM drive.

2. Browse to the Security Key Setup directory.

3. Double-click SentinelSystemDriver.msi.

4 Follow the on-screen prompts to complete installation of the Sentinel system driver.

Once completed, re-run Unity setup. Cisco recommends to run the setup on the local system console instead of using the terminal service window, but I've done remote installs using VNC with no problems.

Nancy

New Member

Re: Unity 4.2 installation problem

I'm getting the same error and I've tried both through terminal services and directly at the console. I found someone else on the forum is getting the same error with no resolution. Has anyone found a solution to this?

Here's a link to the other thread:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=IP%20Communications%20and%20Video&topic=Unified%20Communications&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1dd8b032

106
Views
10
Helpful
2
Replies