Had a working Unity 421 UM e2k, system went into UMR mode. When running the perm wizard I can select the mailstores ok but during Message Store Configuration Wizard I can locate the exchange server but cannot see any of the mailstores. Exchange is up and working ok. mailstore drop down box is empty - any advice appreciated,
Are you still having problems with this? Just saw this post - I've seen similar behavior with perm wizard when the DC Unity server was using was NOT also a global catalog server. Also make sure you are running the correct version of Exchange system manager tools (Exchange 2000) on the Unity server.
Ginger, thanks for your response, much appreciated. The DC was also a GC and I've just checked that the system manager was e2k. We have resigned to rebuild unfortunetly(although I think we may hit same problem as I think its still a customer exchange permissions issue - I have run perm wiz so many times and manually checked rights and all seems ok).
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...