Unity 5.0(1) VPIM Networking with Avaya Interchange
Have completed an VPIM integration between Unity 5.0(1) and Avaya Interchange. Both system is able to send message to each other. There is now one problem - on the system behind the Avaya, the message that gets sent form the Unity has either no message body or the message body is not audible. Vcard (voice name) were sent over and can be played back. It work before but not sure why it did not work after certain point?
What could be the issue? What are the logs that I can check to see what's the issue? Thanks!
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...