I finished building a lab with CM6, Unity 5 and Exchange 2007 SP1.
I did all the steps as the manual shows and all went through.
Unity is up and running, and Syscheck shows no problems with Exchange.
When I try to import users, nothing is listed and I can not see any users in the Domain to import.
Below are the errors I get in the event log.
Any help will be great
Message: An attempt to access the Primary Exchange Mailbox Store by %1 via MAPI has failed. The MAPI subsystem return the following error: %2.
An attempt to access the Primary Exchange Mailbox Store by %1 via MAPI has failed. The MAPI subsystem return the following error: %2.
Message: An occurred which prevents successful Exchange access by %1 via MAPI.%n%nThis is typically an indication of configuration issues with Unity, Exchange, or the MAPI subsystem.%n%nVerify that the Unity services accounts are granted the correct permissions and that there are no issues with installation. The SysCheck utility may assist in diagnosing the problem.
Message: Doh logon failed due to messaging component logon error: %1
Doh logon failed due to messaging component logon error: %1
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...