We have several Unity 7.0.2 unity servers configured, both on W2K and W2K3. This morning, user reported that when they try to access the CiscoPCA, they get the following error (see attached bitmap for full error). We are also getting this on the Unity server itself when trying to open the ciscopca. The WebSA opens fine, but the media master bar is presented by a red X.
"Logon failed because the CiscoPCA Media Master was not found"
I have reviewed the troubleshooting document and all of it discusses the workstation only, but the media master is not displayed on the server and I am not sure how to go about reinstalling/reenabling the media master on the server itself. I have a TAC ticket open on this but they have not yet been able to resolve this.
By all accounts, this was working as one of the servers was upgraded over two months ago and our first complaint was today so not sure if something has changed or if this has been the case all along. The second server whichis reporting this issue was upgraded over the weekend.
Re: Unity 7.0.2 Media Master not installed / working
Hi Art..yes, its been a long time. You know as well as anyone that my "customer" is very security saavy...but if they had done this, it would be affecting all servers as they are in the same OU / policy. (and I just confirmed this is indeed the case, all 7.x servers are experiencing the same issue). I have asked them to review any changes but they insist none have been made..will post my findings later. Hope you are doing well and thanks for the feedback.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.