Re: Unity 7.0(2) - One of the drive has constant red light
Not sure if your running Unity or Unity Connection. Either way, you should open up a TAC case. They will then determine if the drive is bad and then have it replaced if needed.
Typically, if not all Unity servers have Mirror drives. This means you should be able to pull the drive out and replace it with another drive. IF you are running windows, you should be able to use the HP Array software in the Start Programs applications to check on the array and see what failed.
Run a DIRT or DRS backup soon also.
I had had a few HP servers where the light was nothing if I pulled the drive for a bit, then popped it back in, the RAID was built and it was fine. But it possible, the drive has failed and needs to replaced with the same size/speed part number, etc.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4