Install of unity connection 2.1 from CD is good until it gets to the end. I get a "security configuration failed" error. The security password is a strong password. The security password is used "to authenticate between clusters", however, I am only using one unit connection server. Any help with this appreciated
Thanks for the fast reply, i tried a couple more simple PW and it's not taking. It runs the Security Configuration and comes back with the same error. I'm not sure if this might be a part of the problem, but when it completed the install and i was getting the error i noticed the DVD ejected itself. should i pop the DVD back in and try again?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...