Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

Silver

Unity Connection 7: RAID Caveats

Anyone have any comments with regards to this. Does it blow up if I put a disk in there with data on it? I understand if it will be overwritten, which is what I want. Can I simply install it in another system and remove and recreate the partition to make it "blank" ?

From the release notes:

=========================

Replacing Disks in a RAID

Connection supports only replacing a defective disk in a RAID with a blank disk to repair the RAID. Replacing disks in a RAID for any other reason is not supported.

Caution Do not replace a disk in a RAID with a disk that contains data, even if the replacement disk was originally a disk in the same RAID in the same server.

=======================

4 REPLIES

Re: Unity Connection 7: RAID Caveats

Wow, i have not seen this as well. I wonder if it's the same on CUCM....

Cisco Employee

Re: Unity Connection 7: RAID Caveats

Hi

I believe you can do it, but it's not supported by Cisco of HP.

I think the CAUTION note is so that when the drives are synchronized the one with incorrect or old data is not copied to

the correct/working drive on a working/production server. Usually to avoid customers using another disk to do a backup.

This must be done using DIRT. RAID HW is meant for storage device fault tolerance, not for "manual" application data backup or

restoration.

There have been customers who put the wrong drive back later and make a mess of their system.

HTH

Regards,

Teresa.

Regards, Tere. If you find this post helpful, please rate! :)
Silver

Re: Unity Connection 7: RAID Caveats

Fair enough. We typically did it to save time in the event of a DIRT restore. I think we will have to look at a different ways or minimally a way to "blank" a disk using a spare box before putting it in.

I would hope that the H/W RAID system is smart enough to know that when I stick in a drive it should use the existing disk and replicate that onto the newly inserted disk. However, I can see this happen if people power down their system, stick another drive with data on it and the system comes up with whichever drive had the 'master' config or newer date or whatever.

Cisco Employee

Re: Unity Connection 7: RAID Caveats

Yeah, it's kind of risky! that's why we don't recommend it or support it hehe :)

Regards, Tere. If you find this post helpful, please rate! :)
167
Views
0
Helpful
4
Replies
CreatePlease to create content