Unity Connection 8.6, can leave message but it says I have nothi
One thing to check - just to ensure you aren't chasing your tail - is that CXN is matching the mailbox you think it is. You can see this with the Remote Port Status Monitor.
Assuming that's all in order, is this a single-node or CXN cluster? Are there multiple clusters in the site or just one? If there is more than one server involved it's possible that there is a replication issue.
Re: Unity Connection 8.6, can leave message but it says I have n
It turns out that configuration seemed to be OK, user was able to access his VM, change greetings, call other user's extensions, etc. but for some reason, he was not receiving messages confirmed as successfully sent.
I erased the user, I imported it again and it started working as expected. It makes no sense but it's working now.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.