Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Unity Connection Caller System Transfer


I have Unity Connection 7.1(3a) integrated with CUCM 7.1(3a).

I have configured a Call Handler to direct callers to the Caller System Transfer converstion.

Users dial a CTI Route Point DN which forwards to Unity Connection and hits a Call Routing rule which send the caller to my Call Handler.

The caller is prompted to enter a number to be transferred to and then confirm this by pressing 1.

This works ok with the exception that when I dial from an IP phone and enter the extension of another IP phone it takes approx 10 seconds before the two phones are connected - i.e. I am connected to a VM port and so is the called party. After 10 seconds expires the voicemail system drops out of the call and the two phones are connected and we can speak.

oddly enough when the Call handler is accessed from an external phone dialling into the cluster via a PRI gateway no delay is experienced - the phones are connected together as soon as the called party answers.

Any ideas on what the problem may be?


Re: Unity Connection Caller System Transfer


I have just done some more testing and this delay is only being experienced when the calling phone is a 6921. When using 794x it works fine.

This customer only has one 6921 phone (they bought one to evaluate and were not too impressed!) so I am not going to take the troubleshooting any further.

Thanks to everyone who looked.