Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

unity connection cannot assign IP address

Hi,

I've got a 2811 ISR with a AIM-CUE module installed.

The 2811 is also acting as the router for all the vlan's in the network.

Vlan 2 is the voice vlan :

interface FastEthernet0/1.2

description VOICE

encapsulation dot1Q 2

ip address 192.168.130.2 255.255.255.224 secondary

ip address 192.168.130.30 255.255.255.224

The secondary IP address 192.168.130.2 is being used as the CME IP address.

This is what is configured on the Service-Engine0/0 interface :

interface Service-Engine0/0

no ip address

service-module ip address 192.168.130.3 255.255.255.224

service-module ip default-gateway 192.168.130.30

When I try to give IP address 192.168.130.4 255.255.255.224 to this interface, I am getting an error:

netconrtr01(config-if)#ip address 192.168.130.4 255.255.255.224

% 192.168.130.0 is assigned as a secondary address on FastEthernet0/1.2

netconrtr01(config-if)#

Any help is much appreciated.

Rgds,

Jeroen

1 REPLY
New Member

Re: unity connection cannot assign IP address

OK,I figured it out.

I added this uder my interface service-engine0/0

ip unnumbered FastEthernet0/1.2

and then added a route to the ervice module :

ip route 192.168.130.3 255.255.255.255 Service-Engine0/0

Rgds,

Jeroen

121
Views
0
Helpful
1
Replies