Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unity Connection rel 7 MWI request

How can we set up the number of MWI request  ?

What happens if all ports with that feature enable are busy?

1 REPLY
Hall of Fame Super Red

Re: Unity Connection rel 7 MWI request

Hi Diane,

Changing MWI Settings

Messaging waiting indicators (MWIs) control whether Cisco Unity Connection sets MWIs for users and how retries for MWI requests are handled.

To Change MWI Settings

Step 1 In Cisco Unity Connection Administration, expand Telephony Integrations, then click Port Group.

Step 2 On the Search Port Groups page, click the display name of the port group for which you want to change the MWI settings.

Step 3 On the Port Group Basics page, under Message Waiting Indicator Settings, change the applicable settings and click Save.


http://www.cisco.com.az/en/US/docs/voice_ip_comm/connection/7x/administration/guide/7xcucsag240.pdf


Message Waiting Indicator Settings

Enable Message Waiting Indicators

Check this check box so that voice messaging ports in the port group are enabled to turn message waiting indicators (MWIs) on and off. Only the voice messaging ports that have the Send MWI Requests check box checked turn MWIs on and off.

Uncheck this check box so that turning message waiting indicators (MWIs) on and off is disabled for all voice messaging ports in the port group. Even when voice messaging ports have the Send MWI Requests check box checked, they do not turn MWIs on and off.

Default setting: Check box checked.

MWI On Extension

(Cisco Unified CM SCCP integrations only) Enter the extension that you specified in Cisco Unified CM Administration for turning MWIs on.

MWI Off Extension

(Cisco Unified CM SCCP integrations only) Enter the extension that you specified in Cisco Unified CM Administration for turning MWIs off.

Delay Between Requests ____ Milliseconds

Enter the minimum length of wait time, in milliseconds, between subsequent MWI requests.

Default setting: 0 milliseconds.

Maximum Concurrent Requests

Enter the maximum number of messaging waiting indicator (MWI) requests that are attempted at the same time so that a spike in MWI requests does not demand a large portion of Cisco Unity Connection resources.

Default setting: 0 requests.

Retries After Successful Attempt

Enter the number of times an MWI request is retried after success is reported so that MWI success is assured.

Default setting: 0 retries.

Retry Interval After Successful Attempt ____ Milliseconds

Enter the wait time, in milliseconds, between MWI retries that occur after success is reported.

Default setting: 5 milliseconds.

http://www.cisco.com/en/US/docs/voice_ip_comm/connection/7x/gui_reference/guide/7xcucgrg120.html#wp1055834


Determining the MWI Port Activity

Do the following procedure to generate a report with which you can evaluate the activity of your MWI ports.

To Determine the MWI Port Activity

Step 1 In Cisco Unity Connection Serviceability, on the Tools menu, click Reports.

Step 2 On the Serviceability Reports page, click Port Activity Report.

Step 3 On the Port Activity Report page, select the applicable options for the report.

Step 4 Click Generate Report.

http://www.cisco.com/en/US/docs/voice_ip_comm/connection/7x/troubleshooting/guide/7xcuctsg050.html#wp1054671

Cheers!

Rob

Please support CSC Helps Haiti

https://supportforums.cisco.com/docs/DOC-8895

https://supportforums.cisco.com/docs/DOC-8727

656
Views
0
Helpful
1
Replies
CreatePlease to create content