Unity Connection Version 7.1.3ES9.21004-9 - ports hang if phone disconnects during call
If you call UC and use a port even before authentication and diconnect your phone (pull the ethernet cable) you'll lock that port up for ever -- unless you go into CUCM and reset that port or reboot the VM server.
It appears that there is no idle disconnect?
Sure--this normally wouldn't happen -- unless you are a wireless user and you bump the message button while the phone is on your belt -- then walk out of the coverage area .... it happens. If you don't have 244 ports -- and you have lots of wireless phones -- maybe in a few weeks you'd find your port count too low and impact service.
Anyone seen this before -- better yet, any fix for it?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...