Re: Unity Connections 7.x Unable to route to Contacts from Call
Hi Phil Denton,
You are indeed going on the right track with the
"Allow Transfers to Numbers Not Associated with Users or Call Handlers"
What you're missing is the restriction table which by default doesn't allow any patterns to be dialed.
So in the System Settings go to the Restriction Tables and select the "Default System Transfer", and add a pattern that matches your internal extension or just that specific one.
Now this will permit dialing by extension to those specific patterns, one last thing you should verify is that the CSS assigned to your voicemail ports in UCM has the proper partitions to dial those extension.
Message was edited by: Jonathan Sylvain My bad didn't notice original past was in 2010
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...