Unity Connectivity Requirements for CCM Integration
We've been acquired. The new combined company is expanding the Cisco IPT deployment and none of the design dox I've seen mentions anything other than a LAN connection between Unity and CallManager for the integration requirements. I have a 3 server CCM 4.0(2a)sr2b cluster as well as a 2 server 4.0(4)sr1 Unity co-lo in Dallas. I know I need to keep the next pair of Unity servers 40ms from the Exchange cluster they will be servicing, which is in Irvine, CA. I know that a minimum bandwidth requirement of 45MB is needed for geographically separated Unity pub/sub. Will a WAN link between the CCM cluster in Dallas and the Unity cluster in Irvine have any requirements based on bandwidth or delay minimums to support a PBX integration of Unity in Irvine, and CCM in Dallas?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...