I got an error message when I configure failover config on the secondary Unity server. primary was successful.
- Unity 4.0(3)sp1
[0x1ae]"failed to find the SQL publication on the primary server". The SQL replication is required for Unity failover. Disable all Unity replication using SQL enterprise manager and run this wizard again"
I followed all the configuration as per the instruction. any tips ?
successful the FCW after disable the CSA on both Unity servers and work fine the replication test.
another issue that the replication not works after reboot the both Unity servers and work if I restart the MSSQLSERVER service in the primary Unity. I applied SQL2000 sp3a but no luck and difficult to troubleshooting with my knowledge. please guide.
Ok. So if you reboot both servers at the same time, both servers may not have their services up when the secondary server is trying to replicate. I'd suggest booting one or the other but wait for a few minutes in between each to allow ALL the services of one server to be online.
Unity servers should be on UPS and if that is so, it is unlikely that both servers would ever go down at the same time.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.