Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unity failover problem

Dear All,

I have abig problem, I need to install cisco unity 4.0 with failover and i installed active directory and exchange 2000 on the same server , the firest server integrated succesfully with call manager cluster and work properly , but after install the second server i also install additional domain controller on that server to make high a vailability after configure it and and go to failover step didn't complete Is there any problem in this scenario?

your fast replay is highly appreciated .

2 REPLIES

Re: Unity failover problem

Right, you cant run Failover with Unity and Exchange on the same server. With Unity 5.x or 7.x I a believe you can, it's not an issue.

The guides clearly state you must have Exchange on a separate server from Unity Primary and Failover.

New Member

Re: Unity failover problem

thank you so much for your replay , I already installed the failover with unity and exchange on the same server but when I Installed on the firest server I choose "Typical - install - install" during the installation of the exchange and I choose the "custom-none-install" on the second server and the failover happend and work properly

119
Views
0
Helpful
2
Replies