I have a unity failover setup running. there are two unity server and one exchange server out of the box. Is there any way to have a failvover for exchange server also. I am searching for documents to implement a solution of exchange redundancy in unity failover.
Exchange 2007 clustering will be tested shortly after Cisco Unity 5.0(1) is
released. When it has been qualified, this document will be updated to
indicate that Exchange 2007 clustering is supported and to list requirements
specific to Exchange 2007, if any.
So far testing is not completed and we aren't supporting it until it is. We have already encountered problems with MAPI communications with Ex2k7 and Unity when Ex2k7 failover occurs in a cluster so it is not recommended to impliment such a design at this time.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.