You can use Unity Voicemail only with Exchange 2007, but Exchange 2007 must be a separate box. So if you are doing this, you might as well just use Exchange 2003 for your backend and keep it all on one unity server.
For Exchange, the Mail Store Wizard gives instructions on what to do with Exchange 2007. There is a powershell script that gets created during the Unity install. You copy this to Exchange and run the script. Delegate the correct permissions, etc and you are set to go. There is documentation on Cisco's site to integrate with 2007 and Unity 5.x (4.x is not supported)
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...