05-07-2006 09:43 AM - edited 03-18-2019 05:52 PM
7835-I1-ECS
Installing Unity with "Platform Configuration & RAID" ,
I have 2 physical drives. I used PLATFORM CONFIGURATION DISK and installation create 2
logical drives ( C & D ) not 3 ( C , D & E ). as the documentation states.
PLEASE HELP!
JP
05-07-2006 01:46 PM
JP,
Sounds like your server falls into the Platform Overlay 1 category in which case only 2 logical drives (C and D) are created. Please reference the section "Drive Locations for Files on a Platform Overlay 1 Server" in the link you posted. Also, see the following link for the criteria for Platform Overlay 1, 2, and 3 servers.
http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_data_sheet0900aecd802132ef.html
Hope this helps. If so, please rate the post.
Brandon
05-07-2006 08:48 PM
I agree with Brandon,
Normally servers are ECS1 or ECS2.
ECS2 are configured with 2X RAID 1 hard drives for off-box Message Store.
And ECS1 versions typically have either 3XRAID1 or 2XRAID1 plus RAID10 arrays.
ECS1 are configured for VM only and ECS2 are optimized for UM deployments.
These ECS2 configurations typically posses fewer RAID-configured hard drives,
Platform Overlay 2 category is similar, in many ways to PO1. The primary difference is HD configuration.
HTH
//G
05-08-2006 09:59 PM
Actuall y the important part is this one:
You stated that you only have 2 DRIVES= 2XRAID1 which
is clasified as PO1 per this table:
And not 3 C,D,E which is Table 2. You dont have enough HD to be a PO2.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide