This morning found Unity not answering calls. The only error I found is:
Event Type: Error
Event Source: CiscoUnity_ConvAddrSearch
Event Category: Error
Event ID: 109
Time: 7:21:08 AM
Unexpected entry into a subroutine of the subscriber search conversation. Address Searcher Evaluate Input State should not be called without digits. Possible causes could be memory corruption of a switch integration issue. 205
Several ports showed busy for 23+ hours. I also observed status monitor showing calls coming in but, while listening it was not answering. After rebooting, everything worked fine. Any ideas?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.