Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Unity Permissions Wizard

Any idea why the documentation requires that the wizard be run on a failover secondary server as well as the primary?

Since all the accounts are in the domain and the wizard was already run on the first box, I can't think of the point. Even the wizard pops up and states that this has already ocurred. But there must be a reason to run it on both servers ....

Thanks!

Erik

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Unity Permissions Wizard

Even though all accounts are already in the domain, there are certain permission that need to be set at the local server and hence you need to run it on both servers. An example would be that the accounts need to be added to the Local Administrators group, when the Cisco Unity server is not a domain controller.

Check this link for more info on the permissions set by the wizard

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_installation_guide_chapter09186a008022b8c3.html

Regards,

Anup

1 REPLY
Silver

Re: Unity Permissions Wizard

Even though all accounts are already in the domain, there are certain permission that need to be set at the local server and hence you need to run it on both servers. An example would be that the accounts need to be added to the Local Administrators group, when the Cisco Unity server is not a domain controller.

Check this link for more info on the permissions set by the wizard

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_installation_guide_chapter09186a008022b8c3.html

Regards,

Anup

243
Views
0
Helpful
1
Replies
CreatePlease to create content