Following message appears when trying to remotely access the Unity server:
"Remote Desktop Disconnected - The client could not connect to the remote
computer. Remote connections might not be enabled or the computer might be too
busy to accept new connections. It is also possible that network problems are preventing your connection. Please try connecting again later. If the problem
continues to occur, contact your administrator."
The problem must be somewhere at the Unity server, because it occurs from any pc where we try to setup the RDP session.
The "Terminal Services" service is started.
Via command line I checked the status of the ports via "netstat -a". Port 3389 (default port for Terminal Services) is not in the list. According to what I've read, it should be there with status "LISTENING".
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...