I had installed a new Unity 4.0(4) in a old CCM cluster 3.3(5)
I have configured Unity but I below detail the problem:
I can leave vm in the cisco phones but I cannot hear anythinq when I dial the voice pilot number in the cisco phone. The status monitor of Unity display the vm port busy when I dialled the voice pilot number but the phone didn?t receive packet.(only send it)
In the CCM the ip address of the vm ports are 164.x.x.x (arpa). Is it normal?.
I cleanned arpa table with arp -d* in the unity and ccm servers
but I obtained the same fault 164.x.x.x the voice mail port in the CCM . I rebuilt the vm ports with the same result
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...