I am trying to rebuild a unity 5.0 system using WinOS2003. CIsco does not have a PCD for the MCS model customer has. THey said to use the Cisco WIN2003 operating system disk that was provided in the PCD 2-box set.
When trying to do the OS install, the wizard is asking for the Microsoft Product key. This was not provided not does Cisco TAC have it. I'm being bounced between Cisco licensing, support & tac.
Has anyone had this problem and how was it resolved?
Not sure if this will help or not, but here goes ... Here is an alternative method if the MCS server is an HP model and you have an existing Microsoft Premier Support agreement:
1. Use an HP SmartStart bootable CD to rebuild the server from the ground up, including the RAID logical drives and select the Microsoft Windows 2003 OS
2. When prompted in the SmartStart setup, mount your Microsoft Windows 2003 Server CD and complete the install. Your Premier support or similar contract should allow you to use the Windows 2003 server product key on the back of the CD.
You can tell if you have an HP server by the product number when you purchased the MCS server, i.e. MCS-7845H or 7835H, instead of I (which is IBM), the models I mentioned are HP DL-380 servers, very nice. If you have any other HP branded servers in your data center, each HP server comes with the SmartStart CDs.
Another question - we unpowered one of the two internal disks before the rebuild, to provide us with a failback position. So the OS was installed on one drive. Now that the rebuid is complete, we tried to add back the second drive and were unable to change it from raid 0 to raid 1. Consultant wanted to change disks brom basic to dynamic in order to use the software-based mirroring option.
Cisco TAC says its not supported.
Is there any way to get back to mirrored drives or am I stuck?
I don't have personal experience with this, only rebuilding from the ground up or re-partitioning drives with a product like Partition Magic. I wouldn't attempt this unless I had communicated with TAC and had their full support (and run a Unity DiRT backup in case you need to recover). I don't think Cisco supports software based RAID on Unity servers.
I saw your note around 3:00 PM today. Hope by this time you got a fix!! I do not have experience with IBM servers, nor have I ever used the platform configuration disks to build a Unity server. I did some checking on Cisco and found, for example, that CUCM installs look for a specific BIOS level, I'm thinking the PCD is doing the same. But if you haven't already, I would contact TAC. Maybe there is a way to work with IBM to reset the server bios so that the PCD version 184.108.40.206 will then recognize the server? Sorry wasn't any help!
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...