I have a Unity (VM only) 5.0(1) running on a Windows 2003 server. The UnityAdmin account can authenticate but it never loads it's personal settings. The desktop never comes up. Has anyone run into this before, if so, is there a fix outside of an un-install?
If you have not already tried doing so, I would rerun the Unity permissions wizard and specify the account to be used to administer the server as UnityAdmin. Make sure the account has inheritance enabled so the permissions apply correctly.
Thanks for your reply - I've already done that - seems the only fix is to uninstall Unity, remove the account and re-create it. Log onto the server with the new account, and then re-install Unity. That works!
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...