Hi friends, I'm planning to upgrade my CCM 3.3(4)sr2 to CCM 4.1(3). I have a backup file of my CCM 3.3(4)sr2 using BARS, my question is if there's a some kind of problem if I apply that file backup directly in the CCM 4.1(3) (new installation).
Hope things are going well with you! You can only use BARS with the exact same CCM Version (including SR's), so this won't work :(
This will have to be done in multiple stages to be supported. Stage 1 will be building CCM 3.3(4) on the new Hardware (no BARS issues) then upgrading to CCM 4.1(3).If you don't want to go that way you could do the upgrade to 4.1(3) on the existing servers and then do a 4.1(3) rebuild/restore on the new boxes with the proper BARS (4.1(3)) Backup. Either way would work just fine :)
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...