Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

upgrade CUCM 8.5 to 10.5 using PCD simple migration

Hi,

I have a small customer with CUCM 8.5 Pub and Sub. Pub is located in the DC and all the phones/gateways are registered with Sub at the office. I am using PCD simple migration process so no IP address change.

 

PCD simple migration is a three step process:

 

1) Export the data from Pub and Sub

2) Shutdown the production Pub and install/import configuration into new Pub 10.5.

3) Shutdown the production Sub and install/import configuration into new Sub 10.5.

 

My question is if I put a "pause" after step 2 it should not caused any outage up until that point right because all phones and gateways are registered with Sub onsite?

 

Thanks

Aamir

2 REPLIES
Cisco Employee

Hi Aamir,You need to follow

Hi Aamir,

You need to follow the procedure as documented in the "Migrate Cisco Unified Communications Manager to Release 10.5(1)" section of the PCD Deployment guide here

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/ucmapMigrate/10_5_1/CUCM_BK_M24251C0_00_migrate-procedure-for-cucm_1051/CUCM_BK_M24251C0_00_migrate-procedure-for-cucm_1051_chapter_01.html#CUCM_TK_M065FBB4_00

HTH

Manish

Correct - no impact to the

Correct - no impact to the Subscriber until you proceed with the upgrade.

Hailey

Please rate helpful posts!

538
Views
0
Helpful
2
Replies
CreatePlease login to create content