I'm currently researching the upgrade process to Unity 5.0(1), and I would like some advice on a few configuration issues. I have 2 clusters with Unity 4.0(5) VMO, both with failover and they are digitally networked together. One cluster is running server 2000. The other cluster is running server 2003. I also have off box exchange. The upgrade path I'm thinking of doing is to do a rolling upgrade on the cluster that has 2003 on it, and then on the cluster that is 2000. Take a dirt backup, reload with 2003 install Unity 4.0(5) back on it and then do a dirt restore. Once the dirt is complete then do the rolling upgrade to Unity 5 on this cluster. I have a question though about this, can you have a Unity 4.0(5) and a Unity 5 cluster digitally networked together? Any help or advice is greatly appreciated.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...