Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

UPS Client for Communications Manager Ver 5 / 6

Does anyone know whether there is a UPS client for the Communications Manager version 5/6? Customers who were on Version 4 had a UPS client installed on the CUCM to power the system down in the event the UPS power is lost

2 REPLIES
Super Bronze

Re: UPS Client for Communications Manager Ver 5 / 6

Hi

See this excerpt from the CM6.1 OS Admin Guide:

show ups status

This command shows the current status of the USB-connected APC smart-UPS device and starts the monitoring service if not already started.

This command to give full status is only available on 7835-H2 and 7825-H2 servers.

Command Syntax

show ups status

So yes - this doesn't appear in CM5.x so I think it was added in version 6.

Regards

Aaron

Please rate helpful posts.

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
Community Member

Re: UPS Client for Communications Manager Ver 5 / 6

Aaron,

Thanks for your quick response. I wasn't aware this command existed.

Regards, Keith.

100
Views
9
Helpful
2
Replies
CreatePlease to create content