Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Use G729 between CUCM and CCME on IP WAN

Hi

I have cucm 8 with router 2900 voice gateway on central site and CCME on 6 remote site (let say site A,B,C,D,E,F)

I need to reduce IP phone to ip phone call bandwidth on IP WAN between some site

Now I use G711 for all call

see below what  I plan to do

- Use G729  for call between cucm IP phone and ccme ip phone site (A,B,C,D)  and between ccme site (A,B,C,D)

- Internal ip phone call on each site (central site and site A,B,C,D,E,F)  will use G711 as now

- ip phone Call going and comming from site E and F to all other site (central site and site A,B,C,D) use G711 as now

I dont know how to implement it

I am new on this type of configuration

I already installed PVDM card on voice gateway and CCME

I need transcoding only for ip phone to ip phone call on the IP wan between some site

I use ip phone : 7962, 7942, 6921, 7911

Please help

Everyone's tags (7)
4 REPLIES
Cisco Employee

Use G729 between CUCM and CCME on IP WAN

Configure the region between the CUCM phones and the H323/SIP trunk you use to reach CME to use G729.

On CME configure G729 directly under the VoIP DPs you use to reach other CMEs/CUCM or use a voice-class codec config.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Hall of Fame Super Silver

Use G729 between CUCM and CCME on IP WAN

Change your dial-peer configuration pointing to site other sites that you want to use G729 to use G729 codec, you do not need any transcoders for this. Basically assume site A to site B calls as 4XXX, your dial-peer should be :

dial-peer voice 10 voip

description site B

destination-pattern 4...

session target ipv4:x.x.x.x

codec g729r8

no vad

On CUCM you will need to change the region configuration to use G729 pointing to the CME GWs.

HTH,

Chris

New Member

Re: Use G729 between CUCM and CCME on IP WAN

Thanks for your answer

I will try it

I wich case do I need transcoding ?

If I change only the codec as you suggest, conference call will still work ?

If not how can I configure it ?

Regards

Nic

Hall of Fame Super Gold

Use G729 between CUCM and CCME on IP WAN

I would recomend you think over and keep G.711 configured as only codec.

Let alone the bandwidth saving, that in today's networking is marginal, you will enjoy a better call quality, simplicity, and stability.

991
Views
0
Helpful
4
Replies
CreatePlease to create content