Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

user & pass required for new NM-CUE ????

I'm trying to configure NM-CUE Cisco Unity Express 3.0.1 on a 3845

I have already set the commands

interface Service-Engine1/0

ip unnumbered GigabitEthernet0/1

service-module ip address 192.168.1.2 255.255.255.0

service-module ip default-gateway 192.168.1.1

If I try to access by the command :

CME#service-module service-Engine 1/0 session

Trying 192.168.1.1, 2066 ... Open

User Access Verification

Username:

A user and pass is asked but I have no configured nither the user nor the pass, is a new module

Is there a default pass in order to access to the module?

I tried to reset the pass via command but this message is displayed:

CME#

Mar 11 18:44:37.521: %SERVICEMODULE-3-PASSWORDRESET: Service module Service-Engine1/0 password reset not supported

C3845-ADVENTERPRISEK9-M), Version 12.4(15)T3

How can I have access to the module?

2 REPLIES

Re: user & pass required for new NM-CUE ????

Check the authentication settings on the terminal line associated with the CUE module. In your case you should have "line 66" in your config. Sounds like there is a username/password required for this line.

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: user & pass required for new NM-CUE ????

Thanks a lot for your quick response.

I'm going to check it

191
Views
0
Helpful
2
Replies
CreatePlease to create content