Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Using an ECS server for Callmanager?

Hi! Is it possible to use a MCS-78xx-xx-ECS server (for Unity) to install a Callmanager Server?

By my experience with old OS versions (2000.2.x) it is not possible, but I saw a compatibility matrix that says so for newer versions of OS. Has anybody had this experience?

Regards,

Ariel

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Using an ECS server for Callmanager?

looks like no:

This Cisco Unified Communications operating system supports new installations for the Cisco Media Convergence Servers (MCS) and Cisco-approved, customer-provided servers that are listed in Table 2. For information about supported upgrades, see the "What Is New in Releases 2000.4.3 and 2000.4.3a" section.

Note Cisco-approved, customer-provided servers must meet exact server configurations.

Note This operating system does not support servers with only "ECS" appended to the end of the model number.

http://www.cisco.com/en/US/products/hw/voiceapp/ps378/prod_release_note09186a00806a4863.html

good luck! (you might be able to do the registry hack to make it think it's a MCS server, but of course, that is not supported by TAC) ;)

1 REPLY

Re: Using an ECS server for Callmanager?

looks like no:

This Cisco Unified Communications operating system supports new installations for the Cisco Media Convergence Servers (MCS) and Cisco-approved, customer-provided servers that are listed in Table 2. For information about supported upgrades, see the "What Is New in Releases 2000.4.3 and 2000.4.3a" section.

Note Cisco-approved, customer-provided servers must meet exact server configurations.

Note This operating system does not support servers with only "ECS" appended to the end of the model number.

http://www.cisco.com/en/US/products/hw/voiceapp/ps378/prod_release_note09186a00806a4863.html

good luck! (you might be able to do the registry hack to make it think it's a MCS server, but of course, that is not supported by TAC) ;)

152
Views
0
Helpful
1
Replies