Using CUPC7/CUPC8.6 and Jabber for windows...unable to access vo
It's not looking for your PIN - that is only used over DTMF-based interactions - it's looking for your CUC password. If the mailbox is synced from LDAP and you have LDAP Auth enabled on CUC, then this would be your AD password. If it's synced over AXL, not synced at all, or LDAP synced but without Auth, then there will be an alphanumeric password field on the mailbox under Edit > Change Passwords.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...