Is this what a an initial startup of a vg 224 should look like. It's an older version but it just frezzes once it gets to the point when it asks if I would want to configure it. Is there anything that seems off?
System Bootstrap, Version 12.4(13r)T7, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2008 by cisco Systems, Inc.
FPGA readonly version:00250027
FPGA upgrade version :No upgrade FPGA version present
ReadOnly FPGA currently running
vg224 platform with 131072 Kbytes of main memory
Main memory is configured to 64 bit mode with parity disabled
Readonly ROMMON initialized
program load complete, entry point: 0x80008000, size: 0xcb40
program load complete, entry point: 0x80008000, size: 0xcb40
program load complete, entry point: 0x80008000, size: 0x196841c
Self decompressing the image : ################################################################################################################################################################################## [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
00045B 0X007C3F43 24 Analog FXS's, 2 FE
0X000F3BB0 public buffer pools
0X00211000 public particle pools
-----------------------------------------------
TOTAL: 0X00AC8AF3
If any of the above Memory Requirements are
"UNKNOWN", you may be using an unsupported
configuration or there is a software problem and
system operation may be compromised.
Rounded IOMEM up to: 11Mb.
Using 8 percent iomem. [11Mb/128Mb]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, vg224 Software (vg224-I6S-M), Version 15.1(4)M7, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2013 by Cisco Systems, Inc.
Compiled Mon 16-Sep-13 04:42 by prod_rel_team
Cisco VG224 (R527x) processor (revision 4.1) with 119808K/11264K bytes of memory.
Processor board ID FHK1418F1FC
R527x CPU at 225MHz, Implementation 40, Rev 3.1
1 On-Board Twenty-Four FXS Analog Voice Module V2.1
2 FastEthernet interfaces
DRAM configuration is 64 bits wide with parity disabled.
63K bytes of non-volatile configuration memory.
System fpga version is 250027
System readonly fpga version is 250027
Option for system fpga is 'system'.
62720K bytes of ATA Slot0 CompactFlash (Read/Write)
System is running with system fpga version 250027 (readonly)
Option set for fpga is 'system'.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: