running connection 7.1.2 with visual voicemail configured. we can access everything on the phone and see what the voimails, however all external calls show up as "Unity Connection" and do not display the External number. If IP Phone A leaves a message for IP Phone B, on IP Phone B it displays correctly that VM was left from IP PHone A......so for internal calls this is working correctly.
Only for external calls that instead of showing the external number is shows "Unity Connection". CLI is definetely being passed from telco to gateway to callmanager.
When we receive the message via IMAP, the subject field is correct.
When using Visual VoiceMail on the phone there is no subject field, it only displays where the call came from and in our case it shows it came from Unity Connection instead of showing the External cli.
So thanks for that link but not quite what we are looking for.
Sounds like some kind of bug with the phone firmware. If its in IMAP, then its in the subject line of all voicemails. Try upgrading or downgrading your phone firmware or if you are using for example 7945, try a 7975
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...