Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

vlan number which is more than 1024

I am testing the voip stuffs. we used many vlans for data,like 200. I want to just add digit "2" to the data vlan, and then get voice vlan number "2200". this way is easy for maintenance. Because everybody are familar with the data vlans.

the first issue comes out, I need open spanning-tree extend system-id in 6513switch. I am worried about whether has some potential risk or limit if I use the extended vlan number which is more than 1024?

Appreicaite your prompt reply...

2 REPLIES
Bronze

Re: vlan number which is more than 1024

Extended (VLAN numbers up to 4096) was first supported on the Catalyst 6000 series in CatOS 6.1(1), and on the Catalyst 4000 series in CatOS 7.2(1). When attempting to add an extended-range VLAN, one of the following messages is displayed (depending on the version of CatOS software):

An example for software version 7.3(2) is as follows:

Switch> (enable) set vlan 1040

VTP advertisements transmitting temporarily stopped,

and will resume after the command finishes.

Cannot set vlans in extended range.

Reduced Mac Address feature is disabled in NVRAM.

Switch> (enable)

An example for software version 6.1(4) is as follows:

K-4003 (enable) set vlan 1040

VLAN Trunk Protocol (VTP) advertisements transmitting temporarily stopped,

and will resume after the command finishes.

VLAN number must be in the range 1..1005.K-4003 (enable)

The following example shows how to enable MAC address reduction and create an extended-range Ethernet VLAN:

Switch> (enable) set spantree macreduction enable

MAC address reduction enabled

Switch> (enable) set vlan 1040

Vlan 1040 configuration successful.

New Member

Re: vlan number which is more than 1024

for 6500switch, I am using version of 12.2(33)SXH, combined catos into one IOS. I didn't meet the problems like macreduction. what i did just go to spanning-tree and enable the "spanning-tree extend system-id".

185
Views
0
Helpful
2
Replies