no need to edit any scripts or the like - you can just configure subscribers to have the after greeting action be "send caller to" the operator, have 0 go to the operator (which is default anyway) and have the "1" key mapped to take a message - folks (or you) will of course have to record the greetings for users to voice this to outside callers.
this can be changed on a per user basis in the SA on the user input page or you can change it for large groups of users with BulkEdit (found in the Tools Depot on your desktop). You can also configure the subscriber templates on your system to be configured this way such that new users are already configured for this.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...