Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VT Advantage/7961 phones

CCM 4.2(3)SR1, 7961 phone (sccp41.8-0-4SR2S) - video enabled

CUVA 2.0.2.0 works on net (as expected), but the phone will fail making off net calls until CUVA is closed and the app is completely exited. Is this normal? If you dial the number, the phone goes through all of the digits then disconnects without ever setting up the call.

1 REPLY
Bronze

Re: VT Advantage/7961 phones

I had the exact same problem. See the link below:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080569b65.shtml

The short version of it is, go to your voice-gateway, go to voice-port config for your PSTN trunk and enter bearer-cap speech. This should get you rolling.

Remember to rate helpful posts!

Jim

91
Views
5
Helpful
1
Replies