Not sure exactly what you are looking for here, but I can tell you the "envelope" information or message properties are by default, played when listening to a voice message. Cisco Unity announces the day, date, and time that the message was sent. You may have this option unchecked.
To Change What Cisco Unity Plays Before and After a Message:
Step 1 In the Cisco Unity Assistant, on the Preferences menu, click Message Playback.
Step 2 Scroll down to the Before Playing Each Message Play section, and check or uncheck any or all of the following check boxes to specify what information Cisco Unity plays before each message:
- Sender's Information
- Message Number
- Time the Message Was Sent
Step 3 In the After Playing Each Message Play section, check or uncheck the Time the Message Was Sent check box to specify whether Cisco Unity plays the message time stamp before playing each message.
There are two ways to modify the voice message if you are using Outlook:
- You can right-click on the VoiceMessage.wav file and select Save As. Copy it to a new drive location on your PC and rename the file. You cannot rename the attachment in the existing voice message in Outlook.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.